DTC P0711:00 [AW6A-EL, AW6AX-EL]SM2445305
DTC P0711:00 [AW6A-EL, AW6AX-EL]

id0502j7817300

DTC P0711:00

TFT sensor malfunction (stuck)
DETECTION CONDITION
• Change in ATF temperature cannot be detected for 10 min or more when driving in D range.
Diagnostic support note:
• The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.
• The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
• PENDING CODE is not available.
• FREEZE FRAME DATA is available.
• The DTC is stored in the TCM memory.
POSSIBLE CAUSE
• Coupler component connector or terminal malfunction
• TFT sensor malfunction
• TCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded on the repair order?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service information availability.
• Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
INSPECT COUPLER COMPONENT CONNECTOR FOR POOR CONNECTION
• Switch the ignition to off.
• Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
• Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
• Is there any malfunction?
Yes
Repair or replace the terminal, then go to Step 5.
No
Go to the next step.
4
INSPECT TFT SENSOR
• Inspect the TFT sensor. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION [AW6A-EL, AW6AX-EL].)
• Is there any malfunction?
Yes
Replace the TFT sensor, then go to the next step.
(See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
No
Go to the next step.
5
VERIFY TROUBLESHOOTING OF DTC P0711:00 COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC using the M-MDS.
• Perform the following procedure to ensure that the DTC has been resolved:
1. Start the engine.
2. Warm up the engine to normal operating temperature.
3. Drive the vehicle in D range for 10 min or more.
• Is the same DTC present?
Yes
Replace the TCM, then go to the next step.
(See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
No
Go to the next step.
6
VERIFY NO DTC HAS BEEN PRESENTED
• Perform the “Reading DTCs Procedure”. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [AW6A-EL, AW6AX-EL].)
• Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [AW6A-EL, AW6AX-EL].)
No
DTC troubleshooting completed.