NO.1 VEHICLE DOES NOT MOVE IN D RANGE, OR IN R POSITION [AW6A-EL, AW6AX-EL]

NO.1 VEHICLE DOES NOT MOVE IN D RANGE, OR IN R POSITION [AW6A-EL, AW6AX-EL]SM2445394

id050310800600

Vehicle does not move in D range, or in R position

DESCRIPTION

• Vehicle does not move when accelerator pedal is depressed.

POSSIBLE CAUSE

• If the vehicle does not move in D range or R position, basically, the malfunction is in the ATX. (Vehicle will move even with a malfunction in the TCM.) Since a malfunction is in the sensor circuit or output circuit is the cause of the malfunction in the ATX, inspect the sensors, output circuit, and the related wiring harnesses.

― Clutch slippage, worn (D range-C1 clutch, One-way clutch, R position-C3 clutch, B2 brake)

• Line pressure low

• Shift solenoid C malfunction

• Shift solenoid D malfunction

• Shift solenoid E malfunction

• Line pressure control solenoid malfunction

• Shift solenoid F malfunction

• Sensor GND malfunction

• Body GND malfunction

• Coupler component malfunction

• Control valve body malfunction

― Selector lever malfunction

― Parking mechanism not operating properly

― Torque converter malfunction

― Neutral position learning is not performed

Note

• Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION [AW6A-EL, AW6AX-EL].)

Diagnostic procedure

STEP	INSPECTION		ACTION
1	• When the vehicle is stopped on a flat, level road and the engine off, does the vehicle move when pushed? (in D range or N, R positions with the brake pedal released)	Yes	Go to the next step.
1		No	Inspect for parking mechanism.
2	• Start the engine. • Does vehicle move when selector lever in between N position and D range?	Yes	Inspect or adjust selector lever. (See SELECTOR LEVER INSPECTION.) (See SELECTOR CABLE ADJUSTMENT.) Perform neutral position learning. (See NEUTRAL POSITION LEARNING [AW6A-EL, AW6AX-EL].)
2		No	Go to the next step.
3	• Stop the engine. • Inspect following solenoids. (See SOLENOID VALVE INSPECTION [AW6A-EL, AW6AX-EL].) ― Shift solenoid C ― Shift solenoid D ― Shift solenoid E ― Shift solenoid F ― Line pressure control solenoid • Are these normal?	Yes	Go to the next step.
3		No	Inspect the coupler component. If normal, replace the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
4	• Perform the stall test. (See MECHANICAL SYSTEM TEST [AW6A-EL, AW6AX-EL].) • Is the stall speed below specified value?	Yes	Overhaul the transaxle and repair or replace any malfunctioning parts. (clutch slippage, worn) (See Automatic Transaxle and Transfer Workshop Manual AW6A-EL AW6AX-EL.)
4		No	Replace the torque converter. (See TORQUE CONVERTER REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
5	• Verify test results. ― If normal, return to the diagnostic index to service any additional symptoms. ― If malfunction remains, inspect the related Service Information and perform repair or diagnosis. • If the vehicle is repaired, troubleshooting completed. • If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.