NO.26 STARTER DOES NOT WORK [AW6A-EL, AW6AX-EL]SM2445419
NO.26 STARTER DOES NOT WORK [AW6A-EL, AW6AX-EL]

id050310803100

26
Starter does not work
DESCRIPTION
• Starter does not work even when in P or N position.
POSSIBLE CAUSE
• Selector lever mis-adjustment
• TR switch malfunction
• Neutral position learning is not performed.
• Transaxle operates in fail-safe function (Starter lock system related circuit open or short)
• Immobilizer system operating or system malfunction.
Note
• Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION [AW6A-EL, AW6AX-EL].)

Diagnostic procedure

STEP

INSPECTION

ACTION
1
• Perform the neutral position learning. (See NEUTRAL POSITION LEARNING [AW6A-EL, AW6AX-EL].)
• Does the problem eliminate?
Yes
Troubleshooting is completed.
If the other symptom occurs, go to applicable troubleshooting procedure.
No
Go to the next step.
2
• Inspect the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION [AW6A-EL, AW6AX-EL].)
• Is the TR switch normal?
Yes
Go to engine system troubleshooting No.3 “WILL NOT CRANK” troubleshooting procedure.
(See NO.3 VEHICLE MOVES IN P POSITION, OR PARKING GEAR DOES NOT DISENGAGE WHEN P IS DISENGAGED [AW6A-EL, AW6AX-EL].)
No
Replace the TCM and perform initial learning procedure.
(See NO.17 EXCESSIVE SHIFT SHOCK FROM N TO D OR N TO R POSITION/RANGE [AW6A-EL, AW6AX-EL].)
3
• Verify test results.
― If normal, return to the diagnostic index to service any additional symptoms.
― If malfunction remains, inspect the related Service Information and perform repair or diagnosis.
• If the vehicle is repaired, troubleshooting completed.
• If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.