id0510008010a5

Caution

• Cleaning the clutch release collar with cleaning fluids or a steam cleaner can wash the grease out of the sealed bearing.

1.Refer to CLUTCH UNIT REMOVAL/INSTALLATION to remove the clutch release collar. (See CLUTCH UNIT REMOVAL/INSTALLATION [L3 Turbo].)

2.Turn the collar while applying force in the axial direction.

acxaaw00000966

• If the collar sticks or has excessive resistance, replace the clutch release collar. (See CLUTCH UNIT REMOVAL/INSTALLATION [L3 Turbo].)

3.Install in the reverse order of removal.

4.Start the engine, and inspect and adjust the following:

• Air bleeding (See CLUTCH FLUID AIR BLEEDING/REPLACEMENT.)

• Bleed the air from the cooling system. (See ENGINE COOLANT REPLACEMENT [L3 Turbo].)

• Runout and contact on pulley and belt

• Leakage of engine oil, engine coolant, transaxle oil.

• Ignition timing, idle speed and idle mixture (CO and HC)

• Engine accessories operation

5.Perform a road test and verify that there is no abnormal vibration or noise.