id051721292000

Caution

• Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1.Select the selector lever to N position.

2.Disconnect the negative battery cable.

3.Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L5].)

4.Remove the under cover.

5.Remove in the order indicated in the table.

am8rrw00002452

6.Install in the reverse order of removal.

7.Inspect the TR switch.

Manual Shaft Nut Removal Note

1.Set the adjustable wrench as shown to hold the manual shaft lever and loosen the manual shaft nut.

am6xuw00001948

Caution

• Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.

TR switch Installation Note

1.Verify that the manual shaft is aligned with N position.

am3uuw00002408

2.Adjust the TR switch between terminals B and C until the resistance becomes 713—788 ohms.

am8rrw00002338

3.Tighten the TR switch installation bolts.

Manual Shaft Nut Installation Note

1.Set the adjustable wrench as shown to hold the manual shaft lever and tighten the manual shaft nut.

am6xuw00001950

Caution

• Do not use an impact wrench. Hold the manual shaft lever when installing the manual shaft nut, or the transaxle may be damaged