OIL PRESSURE SWITCH INSPECTION [FS5A-EL]SM2445477
OIL PRESSURE SWITCH INSPECTION [FS5A-EL]

id051721292300

Caution
• Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

On-Vehicle Inspection

1.Disconnect the oil pressure switch connector.

(1)Remove the under cover.
(2)Disconnect the oil pressure switch connector.
am8rrw00002344

2.Start the engine.

3.Inspect the continuity between the oil pressure switch terminals A and body GND.
am8rrw00002345
• If there is any malfunction, replace the oil pressure switch. (See OIL PRESSURE SWITCH REMOVAL/INSTALLATION [FS5A-EL].)

Oil pressure switch specification

Test Condition

Continuity
In P position
No continuity
In R position
No continuity
In N position
No continuity
In D range
Continuity


Off-Vehicle Inspection

1.Apply air pressure at 400—440 kPa {4.08—4.48 kgf/cm2,58.1—63.8 psi} as shown in the figure.
am8rrw00002346

2.Inspect continuity between the oil pressure switch terminals A and screw part.
am8rrw00002345
• If there is any malfunction, replace the oil pressure switch. (See OIL PRESSURE SWITCH REMOVAL/INSTALLATION [FS5A-EL].)

Oil pressure switch specification

Test Condition

Continuity
Appling air pressure
Continuity
Appling no air pressure
No continuity