TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]SM2445498
TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]

id051723800400

Caution
• Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

1.Disconnect the negative battery cable.

2.Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

3.Disconnect the TCM connector.

4.Remove the clip and disconnect the selector cable.
acxuuw00000523
Caution
• Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.

5.Set the adjustable wrench as shown in the figure to hold the manual shaft lever.
acxuuw00000524

6.Remove the manual shaft nut and washer.
acxuuw00000525

7.Remove the TCM.
acxuuw00000526
Caution
• Do not touch the terminals.
acxuuw00000527

8.Inspect the condition of the connector pin of the coupler component (foreign material, bent pins, broken pins) and O-ring after the TCM is removed.
acxuuw00000528

9.Align the transaxle case and coupler component connector.
acxuuw00000529

10.Be sure to match the position of the TCM marking.
acxuuw00000530
Caution
• Do not turn more than 60° from the marking.

11.Install the TCM.

12.Verify the correct positioning of the TCM and coupler component.
acxuuw00000531

13.Tighten the TCM mounting bolts.

Tightening torque
19.6—29.4 N·m {2.0—2.9 kgf·m, 14.5—21.6 ft·lbf}
Caution
• Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.

14.Install the manual shaft lever and the washer.
acxuuw00000525

15.Set the adjustable wrench as shown in the figure to hold the manual shaft lever, and tighten the manual shaft nut.
acxuuw00000524
Tightening torque
9.8—14.7 N·m {100—142 kgf·cm, 87—123 in·lbf}

16.Install the clip to the selector cable as shown in the figure.
acxuuw00000532

17.Shift the selector lever to P position.

18.Turn the manual shaft lever to P position.

19.Connect the selector cable and install the clip.
acxuuw00000523

20.Connect the TCM connector.

21.Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

22.Connect the negative battery cable.

Warning
• If you replace the ATX or TCM, be sure to initialize the learned values and perform neutral position learning.

23.Perform the neutral position learning. (See NEUTRAL POSITION LEARNING [AW6A-EL, AW6AX-EL].)