id051723801000

On-Vehicle Inspection

Caution

• Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

• Do not damage the terminals.

1.Disconnect the negative battery cable.

2.Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

3.Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

4.Verify that there is no continuity between coupler component terminals B7 and GND, or B8 and GND.

acxuuw00002664

acxuuw00002665

• If there is any malfunction, perform an off-vehicle inspection of TFT sensor. (See Off-Vehicle Inspection.)

5.Install the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

6.Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

7.Connect the negative battery cable.

8.Perform the neutral position learning. (See NEUTRAL POSITION LEARNING [AW6A-EL, AW6AX-EL].)

Off-Vehicle Inspection

Caution

• Do not damage the terminals.

1.Place the TFT sensor and a thermometer in ATF as shown in the figure, and heat the ATF gradually.

acxuuw00002666

acxuuw00002665

2.Measure the resistance between the coupler component terminals B7 and B8.

• If there is any malfunction, replace the TFT sensor. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)