SOLENOID VALVE INSPECTION [AW6A-EL, AW6AX-EL]

SOLENOID VALVE INSPECTION [AW6A-EL, AW6AX-EL]SM2445512

id051723801900

Resistance Inspection (On-Vehicle Inspection)

Caution

• Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

• Do not damage the terminals.

1.Disconnect the negative battery cable.

2.Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

3.Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

4.Measure the resistance between the following terminals.

acxuuw00002671

acxuuw00002672

• If there is any malfunction, inspect the coupler component.

• If the coupler component is normal, replace the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

Solenoid valve resistance (ATF temperature: 20 °C {68 °F})

Terminal	Solenoid valve	Resistance (ohm)
B5—GND	Shift solenoid A	11—15
B2—GND	Shift solenoid B	11—15
B11—B10	Shift solenoid C	5.0—5.6
B17—B18	Shift solenoid D	5.0—5.6
B14—B22	Shift solenoid E	5.0—5.6
B21—B16	Shift solenoid F	5.0—5.6
B9—B4	TCC control solenoid	5.0—5.6
B3—B1	Line pressure control solenoid	5.0—5.6

5.Install the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

6.Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

7.Connect the negative battery cable.

8.Perform the neutral position learning. (See NEUTRAL POSITION LEARNING [AW6A-EL, AW6AX-EL].)

Continuity Inspection (On-Vehicle Inspection)