id051723802300

Caution

• Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

1.Disconnect the negative battery cable.

2.Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

3.Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

Caution

• Do not damage the transaxle case.

• Do not damage the manual shaft.

4.Remove and discard the oil seal using a tape-wrapped flathead screwdriver.

acxuuw00000533

Caution

• Do not damage the oil seal.

5.Using the SSTs and a hammer, tap a new oil seal so that the specified oil seal position is obtained.

acxuuw00000534

Substitution SST

• 49 F026 102 Outer diameter: 27 mm {1.06 in} or more Inner diameter: 15—18 mm {0.60—0.70 in}

6.Install the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

7.Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

8.Connect the negative battery cable.

9.Perform the neutral position learning. (See NEUTRAL POSITION LEARNING [AW6A-EL, AW6AX-EL].)