id060200808100
|
DTC
|
B1317, B1318
|
Battery power supply
|
|
|
DETECTION CONDITION
|
• Low voltage or high voltage are detected at the voltage monitor.
|
||
|
POSSIBLE CAUSE
|
• Battery and/or generator malfunction
• Open or short circuit in wiring harness between EHPAS CM terminal 1B and battery positive terminal
|
||
 |
|||
Diagnostic procedure
| STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT BATTERY VOLTAGE
• Is the battery terminal voltage normal?
|
Yes
|
Make sure that battery terminal connection is okay.
Go to the next step.
|
|
No
|
Charge or replace the battery, then go to Step 6.
|
||
|
2
|
INSPECT BATTERY GRAVITY
• Is the battery specific gravity as specified?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the battery, then go to Step 6.
|
||
|
3
|
INSPECT CHARGING SYSTEM
• Are the generator and drive belt tension normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the generator and/or drive belt if necessary.
Go to step 6.
|
||
|
4
|
INSPECT EHPAS CM POWER SUPPLY CIRCUIT FOR OPEN OR SHORT CIRCUIT
• Start the engine.
• Measure the voltage between following EHPAS CM terminal (wiring harness-side) and ground.
• Is the voltage
9 V or more?
|
Yes
|
Go to the next Step.
|
|
No
|
Repair or replace the wiring harness for open circuit between the EHPAS CM and ground, then go to Step 6.
|
||
|
5
|
INSPECT EHPAS CM GROUND CIRCUIT FOR POOR GROUND OR OPEN CIRCUIT
• Switch the ignition to off.
• Measure the resistance between the following EHPAS CM terminal (wiring harness-side) and ground.
• Is the resistance
within 0—1 ohm?
|
Yes
|
Go to the next step.
|
|
No
|
If there is no continuity:
• Repair or replace the wiring harness for open circuit between the EHPAS CM and ground, then go to the next step.
If the resistance is not
within 0—1 ohm:
• Repair or replace the wiring harness for poor ground, then go to the next step.
|
||
|
6
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory. (See
ELECTRO HYDRAULIC POWER ASSIST STEERING (EHPAS) ON-BOARD DIAGNOSIS.)
• Is the same DTC present?
|
Yes
|
Replace the electric power steering oil pump, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
7
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||