id060200814100

On-Board Diagnostic (OBD) Test Description

― Provides a quick inspection of the EHPAS usually performed at the start of each diagnostic procedure.

― Provides verification after repairs to ensure that no other faults occurred during service.

― Read/clear diagnostic results, PID monitor and record.

Read/clear diagnostic results

• This function allows reading or clearing of DTCs in the EHPAS CM memory.

PID/Data monitor and record

• This function allows access of certain data values, input signals, calculated values, and system status information.

Reading DTCs Procedure

1.Connect the M-MDS to the DLC-2.

2.After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

• When using the IDS (laptop PC)

1. Select “Self Test”.

2. Select “Modules”.

3. Select “EPS”.

• When using the PDS (Pocket PC)

1. Select “Module Tests”.

2. Select “EPS”.

3. Select “Self Test”.

3.Verify the DTC according to the directions on the screen.

• If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.After completion of repairs, clear all DTCs stored in the EHPAS. (See Clearing DTCs Procedures.)

Clearing DTCs Procedures

1.Connect the M-MDS to the DLC-2.

2.After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

• When using the IDS (laptop PC)

1. Select “Self Test”.

2. Select “Modules”.

3. Select “EPS”.

• When using the PDS (Pocket PC)

1. Select “Module Tests”.

2. Select “EPS”.

3. Select “Self Test”.

3.Verify the DTC according to the directions on the screen.

4.Press the clear button on the DTC screen to clear the DTC.

5.Switch the ignition to off.

6.Switch the ignition to ON and wait for 5 s or more.

7.Perform DTC inspection. (See Reading DTCs Procedure.)

8.Verify that no DTCs are displayed.

PID/Data Monitor and Record Procedure

1.Connect the M-MDS to the DLC-2.

2.After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

• When using the IDS (laptop PC)

1. Select “DataLogger”.

2. Select “Modules”.

3. Select “EPS”.

• When using the PDS (Pocket PC)

1. Select “Module Tests”.

2. Select “EPS”.

3. Select “DataLogger”.

3.Select the applicable PID from the PID table.

4.Verify the PID data according to the directions on the screen.

Note

• The PID data screen function is used for monitoring the calculated value of input/output signals in the module.Therefore, if the monitored value of the output parts is not within the specification, it is necessary to inspect the monitored value of input parts corresponding to the applicable output part control. In addition, because the system does not display an output part malfunction as an abnormality in the monitored value, it is necessary to inspect the output parts individually.

DTC Table

PID/DATA Monitor Table