id0740a1908400

Warning

• Vaporization of fuel in the fuel tank could occur depending on the temperature causing the pressure to increase.

• If fuel system related servicing is performed under conditions of high pressure in the fuel tank, the ignition of highly flammable fuel sprayed under high pressure could cause serious injury or death, and damage to facilities and equipment. Fuel can also irritate the skin and eyes.

• To prevent accidents, always loosen the fuel-filler cap to reduce pressure in the fuel tank before performing servicing on the fuel system.

1.Disconnect the negative battery cable.

2.Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [MZR-CD 2.2].)

3.Remove the following parts:

(1)Windshield wiper arm and blade (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

(2)Cowl grill (See COWL GRILLE REMOVAL/INSTALLATION.)

(3)Windshield wiper motor (See WINDSHIELD WIPER MOTOR REMOVAL/INSTALLATION.)

(4)Cowl panel (See COWL PANEL REMOVAL/INSTALLATION.)

4.Remove the nut and set the cooler hose (LO) out of the way as shown by the figure.

acxwzw00000714

5.Remove the bolt and disconnect the water heat silencer.

acxwzw00000720

6.Remove the bolt A and remove the bracket.

acxwzw00000721

7.Disconnect the connector.

8.Disconnect the heater hose No.1 from the A/C unit.

9.Disconnect the heater hose No.2 from the water heater unit.

10.Disconnect the fuel hose.

11.Remove the nut.

12.Remove the bolt B.

13.Remove the water heater unit component.

14.Disconnect the connector.

acxwzw00000722

15.Disconnect the fuel hose.

acxwzw00000723

16.Remove the nut.

17.Remove the fuel pump.

18.Install in the reverse order of removal.

19.Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT [MZR-CD 2.2].)

20.Perform water heater unit Selftest and Prefilling Utility.