id081000801400

Warning

• Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. (See AIR BAG SYSTEM SERVICE WARNINGS.) (See AIR BAG SYSTEM SERVICE CAUTIONS.)

• If the connector is connected and the ignition switch is turned to the ON position with the SAS control module not secured completely using the installation nuts, the SAS control module may detect a degree of impact even when something contacts it lightly, deploying the air bag module and pre-tensioner seat belt accidentally.

Caution

• Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may seriously injure you. If configuration is not completed before removing the SAS control module, DTC B2477 or B1017 will be displayed.

1.Perform SAS control module configuration when replacing it. (See SAS CONTROL MODULE CONFIGURATION.)

2.Turn the ignition switch to the LOCK position.

3.Disconnect the negative battery cable and wait for 1 min or more.

4.Remove the following parts:

(1)Brake boot (MTX) (See CONSOLE REMOVAL/INSTALLATION.)

(2)Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION.)

(3)Shift lever knob (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(4)Console (See CONSOLE REMOVAL/INSTALLATION.)

5.Remove in the order indicated in the table.

acxwzw00000679

6.Install in the reverse order of removal.

7.Turn the ignition switch to the ON position.

• If the SAS control module is replaced, turn the ignition switch to the ON position for 20 s or more after completing the configuration. (See SAS CONTROL MODULE CONFIGURATION.)

8.Verify that the air bag system warning light illuminates for approx. 6 s and goes out.

• If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. (See FLOWCHART.)