id0902i4935700
| DESCRIPTION |
Open circuit in GPS antenna circuit |
|---|---|
|
DETECTION CONDITION
|
• Multi information display detects open circuit in GPS antenna circuit for
5 s or more, while the ignition switch is ACC.
|
|
POSSIBLE CAUSE
|
• GPS antenna connector or terminals malfunction
• Multi information display connector or terminals malfunction
• GPS antenna feeder malfunction
• GPS antenna malfunction
• Multi information display malfunction
|
Diagnostic Procedure
| STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT GPS ANTENNA CONNECTOR CONDITION
• Turn the ignition switch to the LOCK position.
• Disconnect the negative battery cable.
• Disconnect the GPS antenna connector.
• Inspect the connector and terminals (corrosion, damage, pin disconnection).
• Is there any malfunction?
|
Yes
|
Repair or replace the connector or terminals, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT MULTI INFORMATION DISPLAY CONNECTOR CONDITION
• Disconnect the multi information display connector.
• Inspect the connector and terminals (corrosion, damage, pin disconnection).
• Is there any malfunction?
|
Yes
|
Repair or replace the connector or terminals, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT GPS ANTENNA FEEDER
• Inspect the GPS antenna feeder. (See
GPS ANTENNA FEEDER INSPECTION.)
• Is there any malfunction?
|
Yes
|
Replace the GPS antenna feeder, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT GPS ANTENNA
• Make sure to reconnect the disconnected connectors.
• Reconnect the negative battery cable.
• Clear the DTC from multi information display using the M-MDS. (See
CLEARING DTC [MULTI INFORMATION DISPLAY].)
• Turn the ignition switch to the ACC position.
• Perform the “DTC INSPECTION” to confirm the multi information display DTC. (See
DTC INSPECTION [MULTI INFORMATION DISPLAY].)
• Is the same DTC present?
|
Yes
|
Replace the GPS antenna, then go to the next step.
|
|
No
|
Go to Step 6.
|
||
|
5
|
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnect the disconnected connectors.
• Reconnect the negative battery cable.
• Clear the DTC from multi information display using the M-MDS. (See
CLEARING DTC [MULTI INFORMATION DISPLAY].)
• Turn the ignition switch to the ACC position.
• Perform the “DTC INSPECTION” to confirm the multi information display DTC. (See
DTC INSPECTION [MULTI INFORMATION DISPLAY].)
• Is the same DTC present?
|
Yes
|
Replace the multi information display, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY THAT NO OTHER DTCs ARE PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||