DTC U2100:00 [REAR VEHICLE MONITORING SYSTEM]SM2446017
DTC U2100:00 [REAR VEHICLE MONITORING SYSTEM]

id0902z2462600

DESCRIPTION

Rear vehicle monitoring control module (RH) configuration error
DETECTION CONDITION
• Rear vehicle monitoring control module (RH) configuration is not completed.
• Rear vehicle monitoring control module (RH) configuration is not performed.
POSSIBLE CAUSE
• Rear vehicle monitoring control module (RH) configuration error
• Rear vehicle monitoring control module (RH) malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
PERFORM REAR VEHICLE MONITORING CONTROL MODULE (RH) CONFIGURATION
• Perform the rear vehicle monitoring control module (RH) configuration using the M-MDS. (See REAR VEHICLE MONITORING CONTROL MODULE CONFIGURATION.)
• Clear the DTC from the rear vehicle monitoring control module using the M-MDS. (See CLEARING DTC [REAR VEHICLE MONITORING SYSTEM].)
• Perform the “DTC INSPECTION” to confirm the rear vehicle monitoring system DTC using the M-MDS. (See DTC INSPECTION [REAR VEHICLE MONITORING SYSTEM].)
• Is the same DTC present?
Yes
Perform the rear vehicle monitoring control module (RH) configuration again, then go to the next step.
(See REAR VEHICLE MONITORING CONTROL MODULE CONFIGURATION.)
No
Go to Step 3.
2
VERIFY TROUBLESHOOTING COMPLETED
• Clear the DTC from the rear vehicle monitoring control module using the M-MDS. (See CLEARING DTC [REAR VEHICLE MONITORING SYSTEM].)
• Perform the “DTC INSPECTION” to confirm the rear vehicle monitoring system DTC using the M-MDS. (See DTC INSPECTION [REAR VEHICLE MONITORING SYSTEM].)
• Is the same DTC present?
Yes
Replace the rear vehicle monitoring control module (RH), then go to the next step.
(See REAR VEHICLE MONITORING CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCs ARE PRESENT
• Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [REAR VEHICLE MONITORING SYSTEM].)
No
DTC troubleshooting completed.