NO. 7 SPEEDOMETER INDICATION IS DEFECTIVE [INSTRUMENT CLUSTER]SM2446093
NO. 7 SPEEDOMETER INDICATION IS DEFECTIVE [INSTRUMENT CLUSTER]

id0903d5808000

7

Speedometer indication is defective
POSSIBLE CAUSE
• DSC HU/CM malfunction
• PCM malfunction
• TCM malfunction
• Instrument cluster malfunction
• Connector or pin malfunction
• Short circuit in wiring harness between CAN-L, CAN-H and GND
• Open circuit in CAN wiring harness (CAN-L, CAN-H)
• CAN wiring harness (CAN-L, CAN-H) short each other

Diagnostic procedure

STEP

INSPECTION

ACTION
1
• Start the engine, and drive the vehicle.
― Does the speedometer needle move smoothly?
― Does the speedometer needle indicate correct speed?
Yes
Troubleshooting completed.
No
Go to the next step.
2
• Inspect the DTC for the instrument cluster ON-BOARD DIAGNOSTIC SYSTEM.
• Has DTC U0415:68 been recorded in memory?
Yes
Inspect the DTC for the DSC HU/CM.
(See ON-BOARD DIAGNOSIS.)
No
Go to the next step.
3
• Verify that the speedometer needle moves using the M-MDS instrument cluster simulation function SPDMTR.
• Does the speedometer needle move according to simulation function?
Yes
Go to the next step.
No
Replace the instrument cluster.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
4
• Verify following DSC HU/CM PIDs using the M-MDS.
― WSPD_LF
― WSPD_LR
― WSPD_RF
― WSPD_RR
• Dose DSC HU/CM PIDs indicate vehicle speed properly?
Yes
Go to the next step.
No
Inspect for ABS wheel speed sensors, related wiring harnesses, and installation.
(See FRONT ABS WHEEL-SPEED SENSOR INSPECTION.)
(See REAR ABS WHEEL-SPEED SENSOR INSPECTION [2WD].)
(See REAR ABS WHEEL-SPEED SENSOR INSPECTION [4WD].)
5
• Disconnect the negative battery cable.
• Measure the resistance between the DLC-2 terminals F and E.
• Is the resistance below 60 ohms?
Yes
Go to the next step.
No
Go to Step 7.
6
• Disconnect the negative battery cable.
• Inspect the DLC-2 terminals F and E for short to power supply or GND.
• Is there any malfunction?
Yes
Inspect the wiring harness and CAN system-related module.
Repair or replace the malfunctioning part.
No
Replace the instrument cluster.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
7
• Turn the ignition switch to the LOCK position.
• Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Are the terminals normal?
Yes
Go to the next step.
No
Repair or replace the terminal.
8
• Disconnect the negative battery cable.
• Measure the resistance between the instrument cluster connector terminals 2R and 2T.
• Is the resistance 114—126 ohms?
Yes
Inspect the wiring harness and CAN system-related module.
Repair or replace the malfunctioning part.
No
Replace the instrument cluster.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)