NO.2 CD PLAYER/CHANGER DOES NOT EJECT THE CD [CD PLAYER/CHANGER]SM2446128
NO.2 CD PLAYER/CHANGER DOES NOT EJECT THE CD [CD PLAYER/CHANGER]

id0903e5826200

2

CD player/changer does not eject the CD

Possible DTC

Using the M-MDS

B1D19:79

Without using M-MDS (On-board diagnostic test mode)

Audio unit

10:Er01, 22:Er01

Car-navigation unit

Device code 22/error code 01
Possible cause
• Defective CD. (e.g., cracked, badly bent, rough edges, scratch, dirty CD, condensation)
• Non-conventional discs (e.g., 8 cm (3 in) CD, 8 cm (3 in) disc adapter, heart-shaped disc, octagonal disc)
• Poor connection of audio unit connector or terminal (e.g., damaged, bent, pulled-out pin, corrosion)
• Deformed disc is used (e.g., out of specification (thickness), bent disc).
• Multiple CDs are inserted into the CD player at the same time
• Audio unit/car-navigation unit (without integrated multi information display) malfunction
Note
• The CD may be malfunctioning if the CD player/changer does not eject the certain CD only. Inspect the CD player/changer operation using the CD known to be good.

Diagnostic procedure

STEP

INSPECTION

ACTION
1
• Inspect the operation of the audio system other than CD player/changer (e.g. Radio).
• Does other audio system operate?
Yes
Go to Step 3.
No
Go to the next step.
2
• Turn the ignition switch to the LOCK position.
• Inspect the connection of the audio unit/car-navigation unit (without integrated multi information display) connector (24-pin).
• Inspect both audio unit/car-navigation unit (without integrated multi information display) connector and wiring harness-side connector for poor connection. (such as damaged/bent/pulled-out pins, corrosion)
• All the pins and connector normal?
Yes
Go to the next step.
No
If the audio unit/car-navigation unit (without integrated multi information display) connector/pin is wrong:
• Replace the audio unit/car-navigation unit (without integrated multi information display). (See AUDIO UNIT REMOVAL/INSTALLATION.) (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
If the wiring harness-side connector/pin is wrong:
• Repair or replace the pins and/or the connector.
3
• Eject the CD.
• Is the CD ejected from the CD player/changer?
Yes
Go to the next step.
No
Inspect the panel switch and CD cover installation. Securely install the panel switch and/or CD cover as necessary.
4
• Insert the CD into the CD player/changer.
• Does the CD insert into the CD player/changer smoothly?
Yes
Replace the audio unit/car-navigation unit (without integrated multi information display).
(See AUDIO UNIT REMOVAL/INSTALLATION.)
(See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
No
Install the center panel and/or CD cover properly, then go to the next step.
5
• Is the CD ejected from the CD player/changer?
Yes
Troubleshooting completed.
Explain repairs to the customers.
No
Replace the audio unit/car-navigation unit (without integrated multi information display).
(See AUDIO UNIT REMOVAL/INSTALLATION.)
(See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)