id091200000600

1.Disconnect the negative battery cable.

2.Remove the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

3.Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

4.Remove the liftgate side trim. (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION.)

5.Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)

6.Remove the rear wiper motor. (See REAR WIPER MOTOR REMOVAL/INSTALLATION.)

7.Remove the rear spoiler. (See REAR SPOILER REMOVAL/INSTALLATION.)

8.Remove the high-mount brake light. (See HIGH-MOUNT BRAKE LIGHT REMOVAL/INSTALLATION.)

9.Disconnect the filament connector.

10.Apply protective tape along the edge of the body.

acxuuw00001547

Note

• Overlap and adhere the protective tape to the corners to prevent damage.

11.Insert the piano wire, which has been cut to sufficient length from inside the vehicle.

acxuuw00001551

Warning

• Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire.

Note

• Before removing the rear window glass from the body, mark the position of the glass by affixing tape to the glass and body panel.

12.Wind each end of the piano wire around a bar.

Note

• Use a long sawing action to spread the work over the whole length of the piano wire to prevent it from breaking due to localized heating.

13.Secure one end of the piano wire, and while pulling the other end, cut the sealant around the rear window glass.

acxuuw00001549

14.Remove the rear window glass.

15.Remove the fasteners from the rear window glass.

Note

• Place alignment marks on the rear window glass before removing the fasteners from the rear window glass.