POWER OUTER MIRROR INSPECTIONSM2446230
POWER OUTER MIRROR INSPECTION

id091200002700


With Rear Vehicle Monitoring System


Mirror glass adjustment, retract/return

1.Disconnect the negative battery cable.

2.Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION)

3.Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION)

4.Remove the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION)

5.Apply battery positive voltage to the power outer mirror terminals and inspect the operation of the power outer mirror.
acxwzw00000788
• If not as specified, replace the power outer mirror.

Mirror operation

terminal

B+

GND
Up
B
D
Down
D
B
Left
F
D
Right
D
F
Retract
A
G
Return
G
A


Heated outer mirror

1.Disconnect the negative battery cable.

2.Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION)

3.Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION)

4.Remove the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION)

5.Apply battery voltage to power outer mirror connector terminal E, and connect terminal C to ground.
acxwzw00000789
• If not as indicated in the table, or if the resistance is not within the specification, replace the power outer mirror.
acxwzw00000790


Without Rear Vehicle Monitoring System


Mirror glass adjustment, retract/return

1.Disconnect the negative battery cable.

2.Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION)

3.Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION)

4.Remove the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION)

5.Apply battery positive voltage to the power outer mirror terminals and inspect the operation of the power outer mirror.
acxwzw00000820
• If not as specified, replace the power outer mirror.

Mirror operation

terminal

B+

GND
Up
G
H
Down
H
G
Left
I
H
Right
H
I
Retract
F
D
Return
D
F


Heated outer mirror

1.Disconnect the negative battery cable.

2.Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION)

3.Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION)

4.Remove the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION)

5.Apply battery voltage to power outer mirror connector terminal A, and connect terminal C to ground.
acxwzw00000821
• If not as indicated in the table, or if the resistance is not within the specification, replace the power outer mirror.
acxwzw00000822