id091300487700

Warning

• Handling the front seats improperly can accidentally deploy the side air bag, which may seriously injure you. Read air bag system service warnings and cautions before handling the front seats. (See AIR BAG SYSTEM SERVICE WARNINGS) (See AIR BAG SYSTEM SERVICE CAUTIONS)

Caution

• After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the slide adjuster may be damaged after the front seat is installed.

• Verify that there are no malfunctions in the sliding mechanism after installing a front seat.

• When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the seat.

1.Turn the ignition switch to the LOCK position.

2.Disconnect the negative battery cable and wait 1 min or more.

3.Disconnect the seat warmer module connector.

4.Remove the following parts:

(1)Front seat (See FRONT SEAT REMOVAL/INSTALLATION.)

(2)Front seat side cover (See FRONT SEAT SIDE COVER REMOVAL/INSTALLATION.)

(3)Front seat front cover (See FRONT SEAT FRONT COVER REMOVAL/INSTALLATION.)

(4)Front seat cushion (See FRONT SEAT CUSHION TRIM REMOVAL/INSTALLATION.)

5.Remove the headrest.

6.Slide hook A in the direction of arrow (1), (2), (3) shown in the figure to detach it from hook B.

acxuuw00004043

7.Open the fastener.

acxuuw00004055

8.Remove the clip C from the front seat back frame in the direction of arrow (4), (5) shown in the figure.

9.Remove the nut. then remove the holder bracket.

acxuuw00004056

10.Remove the clip D then remove the lumber support lever. (Vehicles with lumber supporrt)

acxuuw00004057

11.Partially peal back the front seat back trim, release the pole guide tabs in the direction of arrow (6) shown in the figure, then pull the pole guide out in the direction of arrow (7).

acxuuw00004058

12.Cut the bands securing the seat warmer module wiring harness and side air bag module wiring harness.

acxwzw00001514

13.Remove the front seat back trim and the front seat back pad as a single unit from the front seat back frame by pulling them in the direction of the arrow.

acxuuw00004060

14.Partially peal back the seat back trim from the seat back pad, remove rings C and velcro in the order of (8), (9), (10) shown in the figure, then remove the seat back trim.

acxuuw00004061

15.Install in the reverse order of removal.