id0914008063z6

Caution

• When replacing the keyless control module, the configuration procedure must be performed before removing the keyless control module. Replacing the keyless control module without performing the configuration procedure will result in system malfunction.

Note

• If the keyless control module is replaced, always perform the following procedure.

― Advanced key programming (See CLEARING ADVANCED KEY [ADVANCED KEYLESS ENTRY AND START SYSTEM].)

― Steering lock unit programming (See STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS ENTRY AND START SYSTEM].)

― Immobilizer system-related parts programming (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [KEYLESS ENTRY SYSTEM].)

1.Perform the keyless control module configuration when replacing it. (See KEYLESS CONTROL MODULE CONFIGURATION [ADVANCED KEYLESS ENTRY AND START SYSTEM].)

2.Disconnect the negative battery cable.

3.Remove the front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

4.Disconnect the keyless control module connector.

5.Remove the bolt, then remove the keyless control module.

acxaaw00001081

6.Install in the reverse order of removal.