id0914008094b7

1.Disconnect the negative battery cable.

2.Remove the following parts:

(1)A‐pillar lower trim (See A-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)

(2)A‐pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(3)Front scuff plate inner (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(4)Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(5)B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)

(6)Front seat belt upper anchor installation bolt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)

(7)B‐pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)

(8)Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)

(9)Sub trunk box (See SUB TRUNK BOX REMOVAL/INSTALLATION.)

(10)Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(11)Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(12)C‐pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(13)D‐pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

(14)Map light (See MAP LIGHT REMOVAL/INSTALLATION.)

(15)Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)

(16)Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

(17)headliner (See HEADLINER REMOVAL/INSTALLATION.)

3.Remove the connector.

acxaaw00001352

4.Remove the intruder sensor.

5.Install in the reverse order of removal.

6.When replacing the intruder sensor, affix tape to the position shown in the figure (sunroof-equipped vehicles only).

acxaaw00001353