id091700803000

1.Disconnect the negative battery cable.

2.Remove the following parts:

(1)Front seat (See FRONT SEAT REMOVAL/INSTALLATION.)

(2)Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)

(3)Joint cover (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

(4)Front scuff plate inner (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(5)Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(6)Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(7)Brake boot (MTX) (See CONSOLE REMOVAL/INSTALLATION.)

(8)Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION.)

(9)Shift lever knob (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(10)Console (See CONSOLE REMOVAL/INSTALLATION.)

(11)B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)

(12)Sub trunk box (See SUB TRUNK BOX REMOVAL/INSTALLATION.)

(13)Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(14)Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(15)Selector lever component (ATX) (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

(16)Selector lever component bracket. (ATX)

(17)Shift lever assembly (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(18)Shift lever bracket (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(19)SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)

(20)Console bracket.

3.Cut away the floor covering as shown in the figure.

acxuuw00001550

Note

• The cut part does not need to match up when installing the floor covering.

4.Remove fastener A, B, C, and D.

acxuuw00000874

5.Take the floor covering out from the opened liftgate.

6.Install in the reverse order of removal.