LIGHTING SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURESM2446394
LIGHTING SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE

id091800439900


Auto light system

Caution
• Perform the auto light/wiper control module configuration after updating the auto light illumination level to assure that the auto light/wiper system operates correctly.
Note
• Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the PERSONALIZATION FEATURES SETTING PROCEDURE.

1.Connect the M-MDS to the DLC-2.
acxuuw00003493

2.After the vehicle is identified, select the following items from the initial screen of the M-MDS.

1. Select the “Module Programming”

3.Then, select items from the screen menu in the following order.

1. Select “Programmable Parameters”
2. Select “Exterior Lighting”

4.Select the item name, and then select option.

M-MDS display

Function

Initial setting

Setting content

Control unit
Autolamp On Setting
The auto light system sensitivity can be adjusted.
Standard (Other)
Standard (Other) / Low (Other)
Auto light/wiper control module

Note
• When the M-MDS is set to "Low (Other)", the auto-light sensor sensitivity decreases, and the TNS and headlight illumination timing is slower.

5.Perform the auto light/wiper control module configuration. (See AUTO LIGHT/WIPER CONTROL MODULE CONFIGURATION.)


Room Light Control System / Turn Light System

• For the room light control system and turn light system, refer to the control system personalization features setting. (See CONTROL SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE.)