id092000802100

Car-navigation Unit Without Integrated Multi Information Display

1.Disconnect the negative battery cable.

2.Remove the following parts:

(1)Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(2)Center panel (See CENTER PANEL REMOVAL/INSTALLATION.)

(3)Car-navigation unit (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)

(4)Front scuff plate inner (driver’s side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(5)Front side trim (driver’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(6)Brake boot (MTX) (See CONSOLE REMOVAL/INSTALLATION.)

(7)Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION.)

(8)Shift lever knob (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(9)Console (See CONSOLE REMOVAL/INSTALLATION.)

(10)Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(11)Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(12)Meter hood (See METER HOOD REMOVAL/INSTALLATION.)

(13)Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

3.Disconnect the GPS antenna connector. (See GPS ANTENNA REMOVAL/INSTALLATION.)

4.Verify that the continuity is as indicated in the table.

acxwzw00001190

• If not as indicated in the table, replace the dashboard wiring harness.

acxuuw00003355

Car-navigation Unit With Integrated Multi Information Display

1.Disconnect the negative battery cable.

2.Remove the following parts:

(1)Dashboard upper garnish (See DASHBOARD UPPER GARNISH REMOVAL/INSTALLATION.)

(2)Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(3)Center panel (See CENTER PANEL REMOVAL/INSTALLATION.)

(4)Multi information display (See MULTI INFORMATION DISPLAY REMOVAL/INSTALLATION.)

(5)Brake boot (MTX) (See CONSOLE REMOVAL/INSTALLATION.)

(6)Front scuff plate inner (driver’s side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(7)Shift lever knob (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(8)Front side trim (driver’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(9)Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION.)

(10)Console (See CONSOLE REMOVAL/INSTALLATION.)

(11)Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(12)Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(13)Meter hood (See METER HOOD REMOVAL/INSTALLATION.)

(14)Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

3.Disconnect the GPS antenna connector. (See GPS ANTENNA REMOVAL/INSTALLATION.)

4.Verify that the continuity is as indicated in the table.

With RDS (radio data system)

acxwzw00001191

Without RDS (radio data system)

acxwzw00001192

• If not as indicated in the table, replace the dashboard wiring harness.

With RDS (radio data system)

acxwzw00001193

Without RDS (radio data system)

acxuuw00003355