id092000809600

Note

• RDS (radio data system) antenna feeder is integrated with the rear wiring harness.

1.Disconnect the negative battery cable.

2.Remove the following parts:

(1)Front scuff plate inner (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)Rear scuff plate inner (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(4)Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)

(5)Sub trunk box (See SUB TRUNK BOX REMOVAL/INSTALLATION.)

(6)Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(7)Trunk side trim (RH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(8)D-pillar trim (RH) (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

3.Disconnect the RDS (radio data system) antenna feeder connector. (See DASHBOARD REMOVAL/INSTALLATION.) (See ANTENNA FEEDER NO.3 REMOVAL/INSTALLATION.)

4.Verify that the continuity between RDS (radio data system) antenna feeder terminals is as indicated in the table.

acxwzw00001194

• If not as indicated in the table, replace rear wiring harness.

acxuuw00003514