id092000813000

1.Disconnect the negative battery cable.

2.Remove the following parts:

(1)Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(2)Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)

(3)Sub trunk box (See SUB TRUNK BOX REMOVAL/INSTALLATION.)

(4)Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(5)Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(6)C‐pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(7)D‐pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

(8)Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

(9)Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

3.Disconnect the antenna feeder No.4 connector. (with RDS (radio data system)) (See ANTENNA FEEDER NO.4 REMOVAL/INSTALLATION.)

4.Partially peel back the headliner.

5.Disconnect the connector.

acxwzw00001256

6.Verify that the continuity between antenna feeder No.3 terminals is as indicated in the table.

acxwzw00001257

• If not as indicated in the table, replace antenna feeder No.3.

acxwzw00001258