id092200968600

Caution

• When replacing the multi information display, the configuration procedure must be performed before removing the multi information display. The multi information display will not operate normally if it is replaced without performing the configuration procedure.

Without Car-navigation System

1.Perform the multi information display configuration when replacing it. (See MULTI INFORMATION DISPLAY CONFIGURATION.)

2.Disconnect the negative battery cable.

3.Remove the following parts:

(1)Dashboard upper garnish (See DASHBOARD UPPER GARNISH REMOVAL/INSTALLATION.)

(2)Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(3)Center panel (See CENTER PANEL REMOVAL/INSTALLATION.)

4.Remove the screws.

acxwzw00001783

5.Lift up the multi information display, then pull it in the direction of the arrow shown in the figure.

acxwzw00001784

6.Disconnect the connector and clips.

acxuuw00003349

7.Remove the multi information display.

8.Install in the reverse order of removal.

With Car-navigation System

1.Perform the multi information display configuration when replacing it. (See MULTI INFORMATION DISPLAY CONFIGURATION.)

2.Disconnect the negative battery cable.

3.Remove the following parts:

(1)Dashboard upper garnish (See DASHBOARD UPPER GARNISH REMOVAL/INSTALLATION.)

(2)Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(3)Center panel (See CENTER PANEL REMOVAL/INSTALLATION.)

4.Remove the screws.

acxwzw00001783

5.Lift up the multi information display, then pull it in the direction of the arrow shown in the figure.

acxwzw00001784

6.Disconnect the connectors and clip.

acxuuw00003350

7.Remove the multi information display.

8.Install in the reverse order of removal.