id094000800400

L.H.D.

Caution

• When replacing the BCM, the configuration procedure must be performed before removing the BCM. Replacing the BCM without performing the configuration procedure will result in system malfunction.

Note

• Perform the theft-deterrent system initialization when the BCM is replaced with a new one.

1.Perform the BCM configuration when replacing it. (See BODY CONTROL MODULE (BCM) CONFIGURATION.)

2.Disconnect the negative battery cable.

3.Remove the following parts:

(1)Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)Brake boot (MTX) (See CONSOLE REMOVAL/INSTALLATION.)

(4)Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION.)

(5)Shift lever knob (MTX) (See SHIFT MECHANISM REMOVAL/INSTALLATION [A26MX-R].)

(6)Console (See CONSOLE REMOVAL/INSTALLATION.)

4.Set the bonnet release lever out of the way. (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

5.Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION.)

6.Remove the dashboard wiring harness connector clip from the BCM.

acxuuw00003688

7.Disconnect the connectors shown in the figure.

acxuuw00003029

8.Remove the bolts shown in the figure.

acxuuw00003030

9.Raise the BCM in the direction of the arrow (1) shown in the figure, pull it in the direction of the arrow (2), and remove the tab from the body.

acxuuw00003031

10.Pull the BCM outward and remove the pin from the body.

acxuuw00003689

11.Remove the BCM.

12.Install in the reverse order of removal.

R.H.D.

Caution

• When replacing the BCM, the configuration procedure must be performed before removing the BCM. Replacing the BCM without performing the configuration procedure will result in system malfunction.

Note

• Perform the theft-deterrent system initialization when the BCM is replaced with a new one.

1.Perform the BCM configuration when replacing it. (See BODY CONTROL MODULE (BCM) CONFIGURATION.)

2.Disconnect the negative battery cable.

3.Remove the front scuff plate (LH). (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

4.Remove the front side trim (LH). (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

5.Remove the glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

6.Remove the dashboard wiring harness connector clip from the BCM.

acxwzw00000429

7.Disconnect the connectors shown in the figure.

acxwzw00000430

8.Remove the bolts shown in the figure.

acxwzw00000431

9.Raise the BCM in the direction of the arrow (1) shown in the figure, pull it in the direction of the arrow (2), and remove the tab from the body.

acxwzw00000432

10.Pull the BCM outward and remove the pin from the body.

acxwzw00000433

11.Remove the BCM.

12.Install in the reverse order of removal.