PASSENGER AIR BAG DEACTIVATION (PAD) SWITCH REMOVAL/INSTALLATION

id081000804100

1.  Disconnect the negative battery cable.

2.  Remove the dashboard under cover.

3.  Remove the order indicated in the table.

acxaaw00000930

1	Switch bezel component (SeeSwitch Bezel Component Removal Note.)
2	PAD switch connector
3	PAD switch

4.  Install in the reverse order of removal.

5.  Turn the ignition switch to the ON position.

6.  Verify that the air bag system warning light illuminates for approx. 6 s and goes out.

•  If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. (See FLOWCHART.)

Switch Bezel Component Removal Note

1.  Access the switch bezel component form behind of the dashboard, and squeeze the tabs of the switch bezel component.

2.  Remove the switch bezel component from the dashboard.