ADJUSTER ANCHOR REMOVAL/INSTALLATION

id081100802000

Warning

•  The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery cable or work carefully, avoiding excessive impact to the lower part of the B-pillar.

1.  Turn the ignition switch to the LOCK position.

2.  Disconnect the negative battery cable.

3.  Remove the following parts:

(1)  Front seat belt upper anchor installation bolt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)

(2)  Front scuff plate inner (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(3)  Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(4)  B‐pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)

(5)  B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)

4.  Remove in the order indicated in the table.

acxaaw00000640

1	Bolt
2	Adjuster anchor

5.  Install in the reverse order of removal.