SECURITY LIGHT 16, DTC U2510/P1260 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)]

id0902e3864500

SECURITY LIGHT: 16

Communication error between the keyless control module and the PCM (no response)

DTC: U2510/P1260

DETECTION CONDITION

•  Communication error between the keyless control module and the PCM (no response)

POSSIBLE CAUSE

•  Malfunction in the wiring harness (CAN line) between the keyless control module and the PCM

•  PCM malfunction

•  Keyless control module malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION

1

VERIFY DTC

•  Are either U0100 or U0073, or both, displayed by the keyless control module?

Yes

Perform troubleshooting according to the corresponding DTC inspection.

(See DTC U0073 [MULTIPLEX COMMUNICATION SYSTEM].)

(See DTC TABLE [MULTIPLEX COMMUNICATION SYSTEM].)

No

•  Replace the keyless control module and perform the programming for the immobilizer system-related parts.
(See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS SYSTEM].)

(See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [ADVANCED KEYLESS SYSTEM].)

•  Go to the next step.

2

VERIFY DTC

•  Using the registered key, turn the ignition switch to the ON position.

•  Is the DTC displayed?

―  Security light: 16

―  M-MDS: U2510/P1260

Yes

Replace the PCM and perform the programming for the immobilizer system-related parts.

(See PCM REMOVAL/INSTALLATION [L3 Turbo].)

(See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [ADVANCED KEYLESS SYSTEM].)

No

DTC troubleshooting completed.

SECURITY LIGHT: 16	Communication error between the keyless control module and the PCM (no response)
DTC: U2510/P1260
DETECTION CONDITION	• Communication error between the keyless control module and the PCM (no response)
POSSIBLE CAUSE	• Malfunction in the wiring harness (CAN line) between the keyless control module and the PCM • PCM malfunction • Keyless control module malfunction

STEP	INSPECTION		ACTION
1	VERIFY DTC • Are either U0100 or U0073, or both, displayed by the keyless control module?	Yes	Perform troubleshooting according to the corresponding DTC inspection. (See DTC U0073 [MULTIPLEX COMMUNICATION SYSTEM].) (See DTC TABLE [MULTIPLEX COMMUNICATION SYSTEM].)
1		No	• Replace the keyless control module and perform the programming for the immobilizer system-related parts. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS SYSTEM].) (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [ADVANCED KEYLESS SYSTEM].) • Go to the next step.
2	VERIFY DTC • Using the registered key, turn the ignition switch to the ON position. • Is the DTC displayed? ― Security light: 16 ― M-MDS: U2510/P1260	Yes	Replace the PCM and perform the programming for the immobilizer system-related parts. (See PCM REMOVAL/INSTALLATION [L3 Turbo].) (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [ADVANCED KEYLESS SYSTEM].)
2		No	DTC troubleshooting completed.