AUTO LIGHT ILLUMINATION LEVEL SETTING

id091800803300

Caution

•  Perform the auto light/wiper control module configuration after updating the auto light illumination level to assure that the auto light/wiper system operates correctly.

Without Using M-MDS

Caution

•  If any of the following occurs, the sensitivity cannot be set properly. Therefore, resume from Step 1.

―  Each procedure and operation interval exceeds 5 s.

―  Procedures are performed incorrectly.

Note

•  Perform the procedure in a condition that allows verification of the headlight illumination because it is necessary to verify the setting condition according to the number of times headlights turn on.

1.  Turn the ignition switch to the ON position with the light switch in the OFF position and pulled back (Flash-to-pass ON).

2.  Switch the light switch from the OFF to TNS position five times and return it to the OFF position.

3.  Pull the light switch back once. (Flash-to-pass ON)

4.  Turn the light switch to the TNS position.

5.  Switch the light switch from the TNS to ON position five times and return it to the TNS position.

6.  Turn the light switch to the ON position.

7.  Switch the light switch from the ON to AUTO position five times and return it to the ON position.

8.  Turn the light switch to the TNS position.

Note

•  Switches to the sensitivity setting mode when the above operations are performed.

•  The headlights turn on for the number of times according to the current setting conditions.

―  Illumination (Two times): Standard sensitivity

―  Illumination (Three times): Low sensitivity

9.  Switch the sensitivity by pulling the light switch back (Flash-to pass ON).

10.  Verify the number of times the headlights turn on and that the sensitivity is set properly.

•  Illumination (Two times): Standard sensitivity

•  Illumination (Three times): Low sensitivity

11.  Perform the auto light/wiper control module configuration. (See AUTO LIGHT/WIPER CONTROL MODULE CONFIGURATION.)

Using M-MDS

1.  Connect the M-MDS to the DLC-2.

L.H.D.

acxaaw00001171

R.H.D.

acxaaw00001172

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Module Programming”.

•  When using the PDS (Pocket PC)

1.  Select “Programming”.

2.  Select “Module Programming”.

3.   Then, select items from the screen menu in the following order.

1.  Select "Programmable Parameters".

2.  Select "Exterior Lighting".

3.  Select "Autolamp On Setting".

4.  Select "Low (Other)" or "Standard (Other)" on the M-MDS to set the illumination level.

Note

•  When the M-MDS is set to "Low (Other)", the auto-light sensor sensitivity decreases, and the TNS and headlight illumination timing is slower.

5.  Perform the auto light/wiper control module configuration. (See AUTO LIGHT/WIPER CONTROL MODULE CONFIGURATION.)