DTC P167B:00 [PCM (SKYACTIV-D 2.2)]


id0102j5150000

DTC P167B:00

Fuel injection amount learning not completed in fuel injection system

DETECTION CONDITION
•  Fuel injection amount learning is not completed
Diagnostic support note
•  This is an intermittent monitor (fuel system).
•  The check engine light does not illuminate.
•  FREEZE FRAME DATA/Snapshot data is available.
•  DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION
Not applicable
POSSIBLE CAUSE
•  Fuel injection amount learning is not completed
•  PCM malfunction
SYSTEM WIRING DIAGRAM
Not applicable


Diagnostic Procedure

Step

Inspection

Results

Action

1
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
Note
•  Recording can be facilitated using the screen capture function of the PC.
•  Record the freeze frame data/snap shot data.
Go to the next step.
2
VERIFY OTHER RELATED DTCs
•  Switch the ignition OFF, and then switch it ON (engine off).
•  Display the DTCs using the M-MDS.
•  Has any DTC other than P167B:00 been stored?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
Go to the next step.
3
PERFORM FUEL INJECTION LEARNING
•  Perform the fuel injection learning.
•  Start the engine.
•  Verify the warning/indicator light condition.
•  Do the warning/indicator lights turn off?
Yes
Go to the next step.
No
Verify that the implementation conditions for fuel injection amount learning are met, and perform the PCM fuel injection amount learning again.
Go to the next step.
4
VERIFY DTCs
•  Reconnect all disconnected connectors and hoses.
•  Refer to the [MEMORY CLEARING PROCEDURE] and clear the DTC.
•  Display the DTCs using the M-MDS.
•  Is DTC P167B:00 displayed?
Yes
Repeat the inspection from Step 1.
•  If a malfunction occurs, change the learning method (use/do not use M-MDS), and perform the fuel injection amount learning again.
Go to the next step.
No
Go to Step 6.
5
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Reconnect all disconnected connectors and hoses.
•  Refer to the [MEMORY CLEARING PROCEDURE] and clear the DTC.
•  Display the DTCs using the M-MDS.
•  Has DTC P167B:00 been recorded?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the PCM, then go to the next step.
No
Go to the next step.
6
VERIFY OTHER DTCs
•  Has any other DTC or pending code been stored?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.