REAR ABS WHEEL-SPEED SENSOR INSPECTION [2WD]

id0415008002a1

Installation Visual Inspection

1.  Inspect the following items:

•  If there is any malfunction, replace the applicable part.

(1)  Excessive play of the ABS wheel-speed sensor

(2)  Deformation of the ABS wheel-speed sensor

Clearance Inspection

1.  Remove the ABS wheel-speed sensor.

2.  Measure the distance between the ABS wheel-speed sensor installation surface and the ABS sensor rotor. This is dimension A.

ac8wzw00002463

3.  Calculate the clearance between the front ABS wheel-speed sensor and the ABS sensor rotor using the following formula:

Clearance (mm {in}) = A-13.85 {0.5453}

4.  Verify that the clearance between the ABS sensor rotor and the ABS wheel-speed sensor is as indicated below.

•  If there is any malfunction, replace it.

Sensor Output Value Inspection

Caution

•  Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor.

1.  Switch the ignition to off.

2.  Connect the M-MDS to the DLC-2.

3.  Select the following PIDs using the M-MDS:

•  WSPD_SEN_LR (LR ABS wheel-speed sensor)

•  WSPD_SEN_RR (RR ABS wheel-speed sensor)

4.  Start the engine and drive the vehicle.

5.  Verify that the display of the M-MDS shows the same value as the speedometer.

•  If there is any malfunction, replace the ABS wheel-speed sensor.