OFF-ROAD TRACTION ASSIST SWITCH INSPECTION [WITH OFF-ROAD TRACTION ASSIST]

id0415008039f2

Note
•  The OFF-ROAD TRACTION ASSIST switch is integrated into the cluster switch.
•  For the OFF-ROAD TRACTION ASSIST switch removal/installation, refer to the cluster switch removal/installation. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

1.  Remove the OFF-ROAD TRACTION ASSIST switch. (See OFF-ROAD TRACTION ASSIST SWITCH REMOVAL/INSTALLATION [WITH OFF-ROAD TRACTION ASSIST].)

2.  Verify that the resistance between the OFF-ROAD TRACTION ASSIST switch terminals B and C is as indicated in the table.

•  If not as indicated in the table, replace the OFF-ROAD TRACTION ASSIST switch.
ac8wzw00004262

OFF-ROAD TRACTION ASSIST switch specification

Terminal

Test condition

Resistance (ohms)
B—C
Switch pressed
83.66—85.34
Switch released
1139.99—1163.01

3.  Apply battery voltage to OFF-ROAD TRACTION ASSIST switch terminal J, and connect terminal I to ground.

4.  Verify that the LED illuminates.

•  If there is any malfunction, replace the OFF-ROAD TRACTION ASSIST switch.