TCM CONFIGURATION [GW6A-EL, GW6AX-EL]

id0517i2119200

Note

•  The TCM is built into the control valve body.

1.  Verify configuration implementation necessity for replacement parts.

Replacement part	Configuration necessity
Control valve body	Necessary
Oil pressure switch	Unnecessary
Automatic Transaxle	Necessary
ON/OFF solenoid	Unnecessary
Coupler component	Unnecessary

2.  Connect the M-MDS to the DLC-2.

3.  After vehicle identification is completed, select the following from the M-MDS initial screen.

1.  [Module programming]

2.  [Configuration/PMI]

4.  Then, select the following from the screen menu.

1.  [TCM]

5.  Perform the configuration following the instructions on the screen.

6.  Verify that no DTCs are stored. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (GW6A-EL, GW6AX-EL)].)

Note

•  When the system is normal, the U-code DTC is output.

7.  Delete the U-code DTC and verify that no DTC is output. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (GW6A-EL, GW6AX-EL)].)

•  If a DTC is displayed, repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6A-EL, GW6AX-EL)].)