AUTO LEVELING CONTROL MODULE INSPECTION

id091800825500

Note

•  The integrity of the auto leveling control module cannot be determined from a single part. When inspecting the auto leveling control module, perform the following procedure.

1.  Connect the M-MDS to the DLC-2.

2.  Perform the DTC inspection for the auto leveling control module and verify if any DTC is detected. (See DTC INSPECTION [AUTO LEVELING CONTROL MODULE].)

•  If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC INSPECTION [AUTO LEVELING CONTROL MODULE].)

•  If DTCs are not detected, repair the malfunctioning location according to the symptom troubleshooting. (See SYMPTOM TROUBLESHOOTING [HEADLIGHT AUTO LEVELING SYSTEM].)