DTC U2107:00 [SAS CONTROL MODULE (ACTIVE BONNET)]

id0802h4880900

System malfunction location

•  SAS control module collision judgement signal output (SCR signal output)

Detection condition

Warning

•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

•  SAS control module output collision judgement signal

Fail-safe

Not applicable

Possible cause

•  Vehicle collision

•  SAS control module operation (deployment)

•  SAS control module outputs SCR signal

•  SAS control module malfunction

System wiring diagram

Not applicable

System malfunction location	• SAS control module collision judgement signal output (SCR signal output)
Detection condition	Warning • Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure. • SAS control module output collision judgement signal
Fail-safe	Not applicable
Possible cause	• Vehicle collision • SAS control module operation (deployment) • SAS control module outputs SCR signal • SAS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step

Inspection

Action

1

PERFORM SAS CONTROL MODULE DTC INSPECTION

•  Clear the DTC for the SAS control module using the M-MDS.
(See CLEARING DTC [SAS CONTROL MODULE (ACTIVE BONNET)].)

•  Perform the DTC inspection for the SAS control module using the M-MDS.
(See DTC INSPECTION [SAS CONTROL MODULE (ACTIVE BONNET)].)

•  Are the same Pending DTCs present?

Yes

Repeat the inspection from Step 1.

•  If the malfunction recurs, replace the SAS control module.
(See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

No

DTC troubleshooting completed.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE DTC INSPECTION • Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (ACTIVE BONNET)].) • Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (ACTIVE BONNET)].) • Are the same Pending DTCs present?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)
1		No	DTC troubleshooting completed.