AUXILIARY JACK/USB PORT/SD CARD SLOT HUB INSPECTION [TYPE-A]

id0920000318ze

Note

•  The integrity of the auxiliary jack/USB port/SD card slot hub cannot be determined from a single part. When inspecting the auxiliary jack/USB port/SD card slot hub, perform the following procedure.

1.  Connect the M-MDS to the DLC-2.

2.  Perform the DTC inspection for the connectivity master unit (CMU) and verify if any DTCs related to the auxiliary jack/USB port/SD card slot hub is detected.

(Refer to the DTC INSPECTION [CONNECTIVITY MASTER UNIT (TYPE-A)] in the workshop manual)

•  If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting.

(Refer to the DTC TABLE [CONNECTIVITY MASTER UNIT (TYPE-A)] in the workshop manual)