REAR SIDE FRAME REMOVAL [PANEL REPLACEMENT]

id098008801200

Symbol Mark

am6zzb00000472

Removal Procedure

1.  Remove the brace reinforcement. (See BRACE REINFORCEMENT REMOVAL [PANEL REPLACEMENT].)

2.  Drill the 19 locations indicated by (A) shown in the figure, then open the end of rear side frame (upper).

ac9uub00000168

3.  Drill the 28 locations indicated by (B) shown in the figure.

Note

•  When drilling the 28 locations indicated by (B) shown in the figure, do not drill a hole all the way through or there could be a problem when installing the new part.

ac9uub00000313

4.  After lifting floor side panel No.1 panel in the direction of arrow (1) shown in the figure, pull it out in the direction of arrow (2).

ac9uub00000162

5.  Rough cut the location indicated by (C) shown in the figure.

ac9wzb00000022

6.  Drill the 4 locations indicated by (D) shown in the figure, then remove the part of trunk floor panel.

ac9wzb00000023

7.  Drill the 14 locations indicated by (E) shown in the figure.

ac9uub00000314

8.  Remove the rear side frame.