DTC INSPECTION [POWER LIFTGATE (PLG) SYSTEM]

id0902e9345400

Caution

•  Some of the PLG system DTCs cannot be stored unless the PLG system is operated. Therefore, always operate the PLG system before performing the DTC inspection.

1.  Connect the M-MDS to the DLC-2.

ac9wzw00001083

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Self Test”.

2.  Select “Modules”.

3.  Select “LTM”.

•  When using the PDS (Pocket PC)

1.  Select “Module Tests”.

2.  Select “LTM”.

3.  Select “Self Test”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  After completion of repairs, clear all DTCs stored in the PLG control module. (See CLEARING DTC [POWER LIFTGATE (PLG) SYSTEM].)