DTC B2982 [BCM]
id0902f5838300
DTC B2982 |
Parking brake switch circuit open |
---|---|
DETECTION CONDITION
|
Open circuit in wiring harness between BCM and parking brake switch
|
POSSIBLE CAUSE
|
• Open circuit in wiring harness between BCM terminal 1K and parking brake switch terminal A
• Parking brake switch malfunction
• BCM malfunction
|
![]() |
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
INSPECT PARKING BRAKE SWITCH CONNECTOR
• Turn the ignition switch off.
• Disconnect the parking brake switch connector.
• Inspect the parking brake switch connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the terminal, then go to Step 5.
|
No
|
Go to the next step.
|
||
2
|
INSPECT BCM CONNECTOR
• Disconnect the BCM connector.
• Inspect the BCM connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the terminal, then go to Step 5.
|
No
|
Go to the next step.
|
||
3
|
INSPECT PARKING BRAKE SWITCH SIGNAL CIRCUIT FOR OPEN CIRCUIT
• Inspect for continuity between BCM terminal 1K (wiring harness-side) and parking brake switch terminal A (wiring harness-side).
• Is there continuity?
|
Yes
|
Go to the next step.
|
No
|
Repair or replace the wiring harness for a possible open circuit, then go to Step 5.
|
||
4
|
INSPECT PARKING BRAKE SWITCH
• Inspect the parking brake switch.
• Is there any malfunction?
|
Yes
|
Replace the parking brake switch, then go to the next step.
|
No
|
Go to the next step.
|
||
5
|
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the BCM memory using the M-MDS.
• Perform the BCM DTC inspection.
(See DTC INSPECTION [BCM].)
• Is the same DTC present?
|
Yes
|
Replace the BCM.
|
No
|
DTC troubleshooting completed.
|