AUTO LIGHT ILLUMINATION LEVEL SETTING

id091800803300

Note

•  Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the AUTO LIGHT ILLUMINATION LEVEL SETTING.

1.  Connect the M-MDS to the DLC-2.

ac9uuw00000452

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Module Programming”.

3.  Then, select items from the screen menu in the following order.

1.  Select “Programmable Parameters”.

2.  Select “Exterior Lighting”.

3.  Select “Autolamp On Setting”.

4.  Select “Standard (All Others)” or “Low (All Others)” on the M-MDS to set the illumination level.

Note

•  When the M-MDS is set to Low (All Others), the auto-light sensor sensitivity decreases, and the TNS and headlight illumination timing is slower.

5.  Perform the procedure as indicated on the screen.

6.  Perform the auto light/wiper control module configuration. (See AUTO LIGHT/WIPER CONTROL MODULE CONFIGURATION.)

Caution

•  Perform the auto light/wiper control module configuration after updating the auto light illumination level to assure that the auto light/wiper system operates correctly.