NO. 1 FUEL GAUGE NEEDLE POSITION INCORRECT [INSTRUMENT CLUSTER]
id0903d5807400
|
1 |
Fuel gauge needle position incorrect |
|---|---|
|
POSSIBLE CAUSE
|
• Fuel gauge sender unit malfunction
• Instrument cluster malfunction
• Connector or pin malfunction
• Fuel gauge sender unit is improperly installed
• Open or short circuit in wiring harness between instrument cluster and ground
• Open or short circuit in wiring harness between instrument cluster and fuel gauge sender unit
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
• Turn the ignition switch to the ON position.
• Verify that the fuel gauge needle does not move after ignition switch is turned off, or the display does not indicate F even though fuel tank is full.
• Is the fuel gauge normal?
|
Yes
|
Troubleshooting completed.
|
|
No
|
Go to the next step.
|
||
|
2
|
• Perform the check code 23 inspection.
• Is there any malfunction?
|
Yes
|
Replace the instrument cluster.
|
|
No
|
Go to the next step.
|
||
|
3
|
• Perform the check code 22 inspection.
• Is there any malfunction?
|
Yes
|
Go to the next step.
|
|
No
|
Go to Step 6.
|
||
|
4
|
• Turn the ignition switch to the LOCK position.
• Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Are the terminals normal?
|
Yes
|
Replace the instrument cluster.
|
|
No
|
Repair or replace the terminal.
|
||
|
5
|
• Turn the ignition switch to the LOCK position.
• Inspect the fuel gauge sender unit connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Are the terminals normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the terminal.
|
||
|
6
|
• Turn the ignition switch to the LOCK position.
• Is the fuel gauge sender unit installed properly?
|
Yes
|
Inspect the fuel gauge sender unit.
|
|
No
|
Reinstall the fuel gauge sender unit.
|
||