DTC P1000 [MZI-3.7]

id0102d2821900

DTC P1000

OBD systems readiness test not complete

DETECTION CONDITION

•  P1000 indicates that the OBD monitor testing is not complete.

POSSIBLE CAUSE

•  The vehicle is new from the factory and has not yet completed an OBD Drive Cycle.

•  The battery or the PCM has been disconnected.

•  OBD monitor malfunction had occurred before completion of an OBD Drive Cycle.

•  The PCM DTCs have been cleared with the M-MDS tester as part of a service process.

DTC P1000	OBD systems readiness test not complete
DETECTION CONDITION	• P1000 indicates that the OBD monitor testing is not complete.
POSSIBLE CAUSE	• The vehicle is new from the factory and has not yet completed an OBD Drive Cycle. • The battery or the PCM has been disconnected. • OBD monitor malfunction had occurred before completion of an OBD Drive Cycle. • The PCM DTCs have been cleared with the M-MDS tester as part of a service process.

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	DTC P1000: INSPECT FOR OTHER DTCS • This test should be used only if DTC P1000 was received in Continuous Memory. Ignore any DTC P1000s in KOEO or KOER. Note • DTC P1000 indicates that all of the OBD monitors have not yet been successfully tested to clear DTC P1000. • Were any other DTCs received with P1000?	Yes	Repair other DTCs. Go to the applicable DTC Troubleshooting.
3		No	Go to the next step.
4	REQUEST TO CLEAR DTC P1000 • Has the customer requested DTC P1000 be cleared from the PCM memory?	Yes	Perform the Drive Mode, then go to the next step. (See OBD DRIVE MODE [MZI-3.7].)
4		No	Inform customer that if the law in the state requires additional driving in order to clear DTC P1000 from the PCM memory, it must be performed before an inspection maintenance test, then go to the next step.
5	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [MZI-3.7].) • Are any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZI-3.7].)
5		No	Troubleshooting completed.