QUICK RELEASE CONNECTOR (EMISSION SYSTEM) CONSTRUCTION/OPERATION [MZI-3.7]


id0116d2152100

•  There are four types of quick release connectors.

Quick Release Connector Type

ac9wzn00000030

Type A Construction

•  An SST is not used with this type.
•  Mainly consists of a retainer and O-ring. The quick release connector is integrated with the fuel hose and therefore cannot be disassembled.
ac9uun00000032

Type B Construction

•  An SST is not used with this type.
•  The connector can be disconnected by pinching the retainer tab pulling the connector.
ac9uun00000440
•  To connect the quick release connector properly, push it into the fuel pipe until a locking click sound is heard.
•  New quick release connectors are fitted with a checker tab that prevents improper fit. This checker tab cannot normally be removed. When the quick release connector is properly connected to the fuel pipe, the lock is released and the checker tab comes off. Due to this, it can be verified that the quick release connector is completely connected.
ac9uun00000030

Type C Construction

•  An SST is not used with this type.
•  Mainly consists of a retainer and O-ring. The quick release connector is integrated with the joint port and therefore cannot be disassembled.
•  When the quick release connector is connected, the fuel pipe projection is locked at the clamp lock point. To release the quick connector lock for each type, follow the procedure in the order shown in each figure.
acxuun00000028

Type D Construction

•  An SST is not used with this type.
•  Mainly consists of a retainer and O-ring. The quick release connector is integrated with the joint port and therefore cannot be disassembled.
•  When the quick release connector is connected, the fuel pipe projection is locked at the clamp lock point. To release the quick connector lock for each type, follow the procedure in the order shown in each figure.
ac9uuw00000309