GENERAL PROCEDURES (SUSPENSION)

id021000800300

Wheels and Tires Removal/Installation

1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque.

Tightening torque

• 107.8—147.0 N·m {11.0—14.9 kgf·m, 79.6—108.4 ft·lbf}

Suspension Links Removal/Installation

1. For the joint sections with rubber bushings, raise the vehicle using a lift, and then temporarily tighten the installation bolts and nuts. Lower the vehicle to the ground and tighten them completely with the specified torque.

Steering Links Removal/Installation

1. If any steering fluid line has been disconnected, perform the following after installation of the power steering components.

― Power steering fluid amount inspection

― Power steering fluid leakage inspection

― Air bleeding

Power steering fluid

ATF M-III, M-V or equivalent (e.g. Dexron®II)

Connector Disconnection

1. Disconnect the negative battery cable before performing any work that requires handling of connectors.