NO.6 RSC OPERATES FREQUENTLY/RSC DOES NOT WORK CORRECTLY [DSC/RSC]
id0403b3815900
6
|
RSC *operates frequently/ RSC* does not work correctly
*: DSC/RSC system contains roll stability control function; DSC indicator light illuminates and goes out and while DSC/RSC is operating.
|
[TROUBLESHOOTING HINTS]
• DSC/RSC HU/CM detected malfunction (input and out put devise malfunction)
• Poor installation of combined sensor and/or steering angel sensor (If any of the above sensors are poorly installed, DSC/RSC may operate intermittently)
• When replacing the DSC/RSC HU/CM, or combined sensor, initialization is not performed (If initialization is not performed correctly, DSC/RSC may not work correctly)
• Tire problem (low or high air pressure, excessive tire wear, different grip level for four wheels)
• Poor installation or malfunction suspension parts (shock absorber, stabilizer)
|
Diagnostic Procedure
STEP
|
INSPECTION
|
ACTION
|
|
1
|
INSPECT DTC IN DSC/RSC HU/CM
• Inspect DTC for the ON-BOARD DIAGNOSTIC SYSTEM.
• Have DTCs been stored in memory?
|
Yes
|
Perform the applicable DTC inspection
(See ON-BOARD DIAGNOSIS [DSC/RSC].)
|
No
|
Go to the next step.
|
||
2
|
VERIFY THAT EACH SENSOR IS INSTALLED
• Are the combined sensor and steering angle sensor securely installed?
|
Yes
|
Go to the next step.
|
No
|
Install the suspect sensor securely.
|
||
3
|
VERIFY EACH SENSOR IS INITIALIZED
• Was initialized performed after replacement of the DSC/RSC HU/CM or combined sensor?
|
Yes
|
Go to the next step.
|
No
|
Perform initialization procedure.
|
||
4
|
VERIFY THAT TIRE CONDITION
• Verify tire condition for following:
• Are tires conditions okay?
|
Yes
|
Go to the next step.
|
No
|
Adjust, repair or replace suspect tire.
|
||
5
|
VERIFY SUSPENTION PART
• Verify vehicle posture.
• Is there an inclination in the posture of the vehicle right and left, left and rear?
|
Yes
|
Inspect the following suspension part:
• Shock absorber
• Stabilizer
|
No
|
Find malfunctioning part according to “intermittent concern troubleshooting”.
|